Mobile Connectors Cabling (Ethernet) - Stahl IC-930-AFZ Serie Manuel D'instructions

8.2.3 Mobile connectors cabling
(Ethernet)
Use of Ethernet cables with the following
characteristics is highly recommended:
• SF/UTP
• Category 5E (or higher)
• 4 pair (PoE+)
• Diameter: from 5mm to 6mm (0.24in)
Cable the mobile connector by operating as follows.
Insert the Ethernet cable using the sealing nut (01),
the cage (02), the gasket (03) and the body of the
connector (04).
04
Fig. 23
Crimp the shielded RJ45 connector supplied.
Carry out the connections as described in the table
(according to the standard specifications: TIA/EIA-
568-B).
CONNECTION OF THE ETHERNET CABLE
Pin number Cable color
1 Orange-White
2 Orange
3 Green-White
4 Blue
5 Blue-White
6 Green
7 Brown-White
8 Brown
Tab. 4
18
03 01
02
Connect the sleeve to the shielded RJ45
connector.
Fig. 24
Delicately pull the Ethernet cable (05) until the
RJ45 connector (06) is completely inserted in the
compartment of the fast connector body.
After inserting the cage and the gasket, tighten the
sealing nut (07).
Pay attention to the fixing. Tightening
torque: From 0.9Nm to 1Nm.
06
Fig. 25
Fig. 26
Complete assembly.
Connect the mobile connector on the fixed
connector and tighten the ring nut.
07
05
MNTCNVX_1915_EN