Displays And Pushbuttons; Functions - Becker Centronic SunWindControl SWC411 Notice D'utilisation

Operating Instructions

Displays and pushbuttons

Reset
SWC411
MAN/AUTO Sliding Switch
When the sliding switch is set to , manual control commands (e.g.: UP, STOP,
DOWN pushbutton commands) are executed and an alarm signal (e.g.: wind
alarm if wind sensor is integrated) given.
When the sliding switch is set to , automatic control commands are executed
(e.g. sun protection function, ...).
Transmission control light
A radio signal is indicated by the transmission control light being lit.
If the battery starts running out, the transmission control light fl ashes during
transmission.
The transmitter power and/or radio range is reduced when the battery is run-
ning low. If the transmission control light is no longer lit when the pushbutton is
pressed, the batteries must be changed.
14
RETRACT button
STOP pushbutton
EXTEND button
Wind threshold control switch
Sun threshold control switch
RESET-button
Transmission control light
MAN / AUTO Sliding Switch
Setting aid
Battery compartment
Programming pushbutton

Functions