Clip Attachment & Detachment; Attach The Clips (5 Steps); Applying The Sling; In Bed (22 Steps) - Arjohuntleigh MAA2070M Notice D'utilisation

Clip Attachment & Detachment
NOTE
spreader bar using the Dynamic Position
sling. See lift IFU for instructions.

Attach the Clips (5 steps)

Make sure the lug is locked at the top end of the

Applying the Sling

In Bed (22 steps)

Apply bed brakes and adjust the height of the bed
Check that the stiffeners are completely inside the
WARNING
To avoid injury during log roll, make sure
there is another caregiver present and/or
use the side rails on the opposite side of
the bed.
Fig. 3
–
S
–
S

Detach the Clips (3 steps)

Make sure that the weight of the resident is taken up
(See Fig. 3 )
Fig. 4
S, L, LL,
L, LL,
L, LL,
(See Fig. 4 )
Make sure the strap is not squeezed in between the
(See Fig. 5 )
Make sure the lug is unlocked at the bottom of the
roll is not possible, use an ArjoHuntleigh sliding
Sliding sheet/tube IFU
Make sure that the centre line is aligned with the
Pull out the remaining part of the sling from under
Continue with the steps on the next page.
Fig. 5
(See Fig. 6 )
Fig. 6
GB