Removing The Sling - Arjohuntleigh MAA2070M Notice D'utilisation

WARNING
To avoid injury to the resident, pay close
attention when lowering or adjusting the
spreader bar.
GB
Slightly lift the resident to create tension in the
WARNING
To avoid the resident from falling, make
sure that the sling attachments are attached
securely before and during the lifting
process.

Removing the Sling

In Bed (13 steps)
Apply bed brakes and adjust the height of the bed
WARNING
To avoid injury to the resident, pay close
attention when lowering or adjusting the
spreader bar.
weight of the resident is taken up by the receiving
(See Fig. 17 )
If using an All Day sling and leaving it under the
resident, make sure to place the sling straps along
Fig. 15
(See Fig. 4 )
(See Fig. 20 )
(See Fig. 5 )
Fig. 16
Make sure that:
All clips are securely attached
All straps are straight (not twisted)
If an adjustment is needed, lower the resident and
make sure that the weight of the resident is taken
up by the receiving surface before removing the
Make sure that:
One caregiver pays attention to the resident's
head and the other caregiver holds up the
resident's feet to prevent them from hitting the
(See Fig. 19 )
Release the brakes on the lift and bring the lift legs
WARNING
To avoid injury during log roll, make sure
there is another caregiver present and/or
use the side rails on the opposite side of
the bed.
rolling is not possible, use an ArjoHuntleigh sliding
Sliding sheet/tube IFU.
(See Fig. 21 )
Log roll the resident to the other side and remove
Make sure the resident is in a comfortable and
Fig. 17
10
Fig. 18