Installation Complete - Subaru J121SVC000 Instructions D'installation

Step 3
Remove dry-fit part from vehicle and turn it around.
Without exposing the tape adhesive, fold the tape liner for each section of tape to allow for removal. For the upper strips of tape,
fold and crease the tape liner so that it is removable from above. For the lower strips of tape, fold and crease the tape liners so
that it is removable from below. See Fig C.
Step 4
Using the Subaru Emblem as visual indicator of center, tack the bottom edge of the part. Once the bottom is secured, start
applying forward pressure while keeping the bottom edge in contact with the vehicle trim. Follow the tape removal sequence
shown in the Fig D and lightly tack the pieces of tape as you remove each strip of liner.In the event of liner break, use the other
end of the tape liner as a backup and pull in the opposite direction.
Step 5
Once all the 4 strips of liner are removed, using both hands, apply firm and even pressure (30 psi) across carbon fiber trunk trim
for 12 seconds to ensure it adheres to the trunk garnish as shown in Fig. E.
Before opening the trunk, confirm there is an even gap between the part and the tail lights. Gently open and close trunk to
confirm clearance.
Do not wash the vehicle for 24 hours following installation of the Carbon Fiber Trunk Trim.
PART NUMBER: J121SVC000
Back

Installation Complete

ISSUE 03
PART NUMBER: J121SVC000
Fig. C
Fig. D
Fig. E
SUBARU OF AMERICA
11/08/21
Front
PAGE 3 / 3