Subaru SOA801P000 Serie Instructions D'installation

INSTALLATION
INSTRUCTIONS
KIT CONTENTS:
TOOLS REQUIRED:
ISOPROPYL
ALCOHOL
*Sealant Adjustment Tool
Part #: HIG11-D5-04 Isopropyl Alcohol
*Sealant Adjustment Tools and Vaughan Rubber Mallets can be purchased, and installation assistance is available through Adell Corporation's Technical
Helpline at 972-226-4600. Helpline hours are Monday through Friday from 7:00am – 3:30pm CST. Orders can be placed at:
MEANING OF CHARACTERS:
: CAUTION – A process that must be
carefully observed in order to reduce the
risk of damage to the accessory/vehicle
and to ensure a quality installation.
STEP ONE: Prepare the Door's Surface
1a
Before installation, confirm there is sufficient clearance between the door edge and the sealant bead for proper seating of the
Door Edge Guard. If not, lightly tap the sealant adjustment tool with rubber mallet to increase clearance.
1b
PART NUMBER:
SOA801P000xx
Door Edge Guard 4 pcs.
Lint-Free Towel
: STOP - Damage to the vehicle may
occur. Do not proceed until process has
been complied with.
CHECK SEALANT IN AREAS INDICATED BY
GREEN LINE. RED LINES INDICATE NO
SEALANT NEEDS TO BE CHECKED DUE TO
CUT OUTS.
ONLY USE THE TOOL IN THE AREA THE DOOR EDGE GUARD WILL BE INSTALLED
ISOPRO
ALCOH
***IMPORTANT***
PREP ALL DOOR EDGES
WITH ISOPROPYL
ALCOHOL TO REMOVE ALL
SURFACE WAX
x4
DATE:
ISSUE:
06-23-15
REV -
PART NUMBER: SOA801P000xx
DESCRIPTION: FORESTER Door Edge Guard
Scissors
Paper Installation
Templates (Pages 4 & 5)
Sufficient
Clearance
Inside
Door
View
SUBARU OF AMERICA
Painter's Tape
*Vaughan 12 oz. Rubber Mallet
Part #: SF12
(or any other 12 oz. Rubber Mallet)
www.orderdoorguards.com
: TOOLS & EQUIPMENT - Specific Tools
and equipment recommended for this
process.
Door
Edge
Adjustment
Tool
Insufficient
Clearance
4mm
Adjustment
Tool
Door Edge
ROTATE TOWEL
AFTER EACH DRY ALL DOOR
WIPE
RESISTANCE MUST
BE FELT &
"SQUEAKY CLEAN"
SOUND HEARD
WHILE DRYING
SQUEAK
EDGES
PAGE
1/5