Mounting The Flash; Mounting The Flash On The Camera; Connection To The Camera; Removing The Flash From The Camera - Metz MECABLITZ 20 C-2 Mode D'emploi

2. Mounting the flash

2.1 Mounting the flash on the camera

Turn off the camera and the flash by the
main switch!
• Push the locking slide ("LOCK") to the right.
• Slide the flash foot completely into the
camera's accessory shoe.
• Then push the locking slide ("LOCK") to the
left and fasten the flash unit.
k

2.2 Connection to the camera

The flash is triggered via the hot shoe contact
in the camera's flash shoe.
If the camera's flash shoe does not have a hot
shoe contact then a synchronising cable can
64
be used to establish the link between the
camera's X socket and the sync socket of the
flash.
Please note: The flash must be switched
off before the synchronising cable is plug-
ged in or disconnected.

2.3 Removing the flash from the camera

Turn off the camera and the flash by the
main switch.
• Push the locking slide ("LOCK") to the right.
• Withdraw the flash from the camera's acces-
sory shoe.