Extension Cord; Settings; Electronics - Festool PLANEX easy LHS-E 225 EQ Guide D'utilisation

Ponceuses autoportées à rallonges
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OFF (0) Push the on/off switch [4-1] down and
unlock it.
On/off switch moves back to the 0 posi-
tion.
4
I
O
WARNING
Risk of injury, electric shock
Always pull the mains plug out of the socket be-
fore performing any type of work on the ma-
chine!

Electronics

The power tool is equipped with a brushless EC-
TEC motor for a long service life and power elec-
tronics with the following properties:
Smooth start-up
The electronically controlled smooth start-up en-
sures that the machine starts up jolt-free.
Constant speed
The preselected motor speed is kept constant
through electronic control to ensure a uniform
sanding speed up to a certain load.
Overload protection
If the pressure becomes too high while working, the
power of the machine will be automatically reduced
12
Use only a 3-wire extension cord that has a 3-blade
grounding plug, and a 3-slot receptacle that ac-
cepts the plug on the product. Make sure you exten-
sion cord is not damaged.
4-1
If an extension cord is required, it must have suffi-
cient cross-section to prevent an excessive drop in
voltage or overheating. An excessive drop in voltage
reduces the output and can lead to failure of the
motor. The table below shows you the correct cord
diameter as a function of the cord length for this
tool.
Total Extension Cord
Lenght (feet)
Cable size (AWG)
Use only U.L. and CSA listed extension cords.
Never use two extension cords together. Instead,
use one long one.
 The lower the AWG number, the stronger the

Settings

to prevent overheating.
Speed control
You can regulate the speed steplessly within the
speed range using the adjusting wheel [1-7] (see
Technical data).
This enables you to optimise the sanding speed to
suit the material you are working on.
Overheating protection
Overheating protection is triggered when the pres-
sure is too high or the cool air openings are dirty.
The power tool beeps three times and switches off.
Let the power tool cool down for approx. 15 minutes
before using it again.

Extension Cord

cord.
25
50
100
150
18
16
16
14

Publicité

Table des Matières
loading

Table des Matières