Extension Cord; Machine Settings; Fitting The P L A N E X - Festool PLANEX LHS 225 EQ Guide D'utilisation

Total Extension Cord
Lenght (feet)
Cord size (AWG)
3
25 50 100
18 16 16
3- 1
3- 2
If an extension cord is required, it must have suf-
fi cient cross-section to prevent an excessive drop
in voltage or overheating. An excessive drop in
voltage reduces the output and can lead to failure
of the motor. The table adjacent shows you the
150
correct cord diameter as a function of the cord
14
length for the LHS 225.
Use only U.L. and CSA listed extension cords.
Never use two extension cords together. Instead,
use one long one.
Note: The lower the AWG number, the stronger
the cord.
Risk of accident, electric shock
 Always pull the plug out of the socket before
performing any type of work on the machine.
Fitting the
 Hold the sanding head [1-1] with the sanding
pad facing downwards.
 If closed, release the clamping levers [3-1]
and [3-2].
 Slide the extension pipe [1-2] into the opening
up to the stop as illustrated in [3].
 Close the clamping levers [3-1] and [3-2].
 Slide the contact slide [4-2] into the retainer
as illustrated in [4].
 Press the contact slide down until it latches
into position.
 Insert the handle section [1-6] at the same way.
 If you wish to use the
walls in cramped spaces, for example, reduce
the length of the machine by fi tting the sanding
head [1-1] directly to the handle section [1-6].
 When disassembling the machine, do not forget
to press the button [4-1] to release the contact
slide before opening clamping levers [3-1] and
[3-2].

Extension cord

Machine settings

WARNING
P L A N E X
P L A N E X
for sanding
11