Intended Use; Electrical Connection And Operation; Extension Cord; Electronic Control - Festool ROTEX RO 150 FEQ Guide D'utilisation

Total Extension Cord
Lenght (feet)
Cord size (AWG)
2 .1
25 50 100
18 16 16
The sanders are designed for sanding and polishing
wood, plastic, metal, composite materials, paint/
varnish, fi ller and similar materials.
Do not use with materials containing asbestos.
The tools must not be used when wet or damp,
or operated in a damp environment, for electrical
safety reasons. Use this sander only for dry sanding.
for any damage or accidents resulting from incor-
rect use.

Electrical connection and operation

The mains voltage must correspond to the voltage
on the rating plate!
connecting or disconnecting the power cord!
it connection if bayonet fi tting is not completely
locked! Before switching on the power tool, make
sure that the bayonet fi tting at the mains cable is
closed fully and locked.
See the adjacent figure for connection and dis-
connection of the power cord.
To start the tool, push the switch (2.1) forwards.
Slight pressure on the rear end of the switch is
suffi cient to switch the tool off.
If an extension cord is required, it must have suf-
fi cient cross-section to prevent an excessive drop in
voltage or overheating. An excessive drop in voltage
reduces the output and can lead to failure of the
motor. The table adjacent shows you the correct
cord diameter as a function of the cord length for
the RO 150 FEQ.
Use only U.L. and CSA listed extension cords. Never
150
use two extension cords together. Instead, use one
long one.
14
Note: The lower the AWG number, the stronger the
cord.
The tool has full-wave electronics with the
following features:
ELECTRON I C
6

Intended use

The user bears sole responsibility
Always switch the tool off before
Risk of burns! Heating of the Plug

Extension cord

Electronic control