Extension Cord; Electronic Control; Tool Settings; Dust Extraction - Festool ROTEX RO 150 FEQ Guide D'utilisation

Total Extension Cord
Lenght (feet)
Cord size (AWG)
3.1
2.1
25 50 100
18 16 16
If an extension cord is required, it must have suf-
fi cient cross-section to prevent an excessive drop in
voltage or overheating. An excessive drop in voltage
reduces the output and can lead to failure of the
motor. The table adjacent shows you the correct
cord diameter as a function of the cord length for
the RO 150 FEQ.
Use only U.L. and CSA listed extension cords. Never
use two extension cords together. Instead, use one
long one.
Note: The lower the AWG number, the stronger the
cord.
The tool has full-wave electronics with the
ELECTRONIC
following features:
Smooth start-up
The smooth start-up ensures jolt-free startup.
150
Speed adjustment
You can regulate the speed steplessly between
14
3300 and 6800 rpm using the adjusting wheel (3.1).
This lets you optimize the sanding speed to suit the
material.
Constant speed
The pre-selected speed remains constant whether
the tool is in operation or in neutral position.
Temperature control
To prevent overheating, the safety electronics
switch the tool off when it reaches a critical motor
temperature. Let the tool cool down for approx. 3-5
minutes before using it again. The tool requires
less time to cool down if it is running, i.e. in neutral
position.
the socket before carrying out any work on the
power tool.
Always connect the machine to a dust ex-
tractor when performing work that gener-
ates dust.
6

Extension cord

Electronic control

Tool settings

Always remove the power plug from

Dust extraction