Unpacking Unit - BLAZE BLZ-20-KAMADO Manuel De L'utilisateur

Before installation or service, disconnect the power supply to the work area by removing the fuse, "tripping"
the circuit breaker, or unplugging the unit.
Keep any electrical supply cord and fuel supply hose away from any heated surfaces, sharp edges and
dripping grease.
Be certain your grill is properly installed and grounded by a qualified technician in accordance with
applicable codes. To guarantee the electrical safety of this grill, continuity must exist between the grill and an
effective grounding system. It is imperative that this basic safety requirement be met. The manufacturer
cannot be held responsible for damages caused by the lack of inadequacy of an effective grounding system.
Do not operate any grill with a damaged power cord or power plug, and do not operate any grill after the grill
malfunctions or has been damaged in any manner. If this should occur, return the grill to the nearest authorized
service facility for examination, repair or adjustment.
Be certain your grill is properly installed and grounded by a qualified technician in accordance with applicable
codes. To guarantee the electrical safety of this grill, continuity must exist between the grill and an effective
grounding system. It is imperative that this basic safety requirement be met. The manufacturer cannot be held
responsible for damages caused by the lack of inadequacy of an effective grounding system.
This grill conforms to all uniform electrical safety codes and electrical grounding regulations. Install unit
according to I.A.W. local codes or with National Electrical Code ANSI/NFPA 70 or CSA C22.1 in their absence.

UNPACKING UNIT:

Your Blaze Series Grill comes pre-assembled and requires very little setup. We do however; recommend the
use of professional help during the installation of your unit as improper installation may affect your warranty.
When moving or transporting your grill, NEVER do so by lifting on the hinge of the grill. Your kamado grill
comes with the attached feet screwed down to the pallet. Remove screws and inner components before lifting.
The lower air inlet can be used for lifting as long as gloves are used. Always use 2-3 people when moving the
grill. Remove the unit from the box along with all accessories and check that no damage has occurred to the
unit or any parts. Various parts of the grill are shipped with protective packaging and supports which will need
to be simply unpackaged and set in place.
Blaze Outdoor Products Instructional Book
Page | 10