Publicité
Les langues disponibles
Les langues disponibles
GB
* Rain sensor
1.
or
2. Activating/deactivating the rain sensor:
■
Activate
or
Activate the rain sensor.
■
Deactivate
or
Deactivate the rain sensor.
3. Setting the delay of the rain sensor:
■
* After rain delay
or
■
xx hours xx minutes
Select the required value for the hour/
minute in sequence with
respectively accept with
7.4
Setting the mowing program
7.4.1
Setting the mowing program – General
1. Call up the main menu with
* Programs
2.
or
3. Select the menu item with
cept with
.
4. Carry out the settings.
Note: The menu items are described in the
following sections.
7.4.2
Setting the start points
Teaching-in start points
1. Place the appliance in the base station.
2. Switch on the appliance with
3. Call up the main menu with
* Programs
4.
or
* Entry Point
5.
or
* Interactive teach
6.
or
* Start interactive entry
7.
or
point teaching
■
Start
or
moves along the boundary cable.
■
Set
or
has reached the required start point. The
start point is stored.
54
:
:
or
and
.
.
or
and ac-
.
.
:
. The appliance
when the appliance
Set entry point 1
8.
or
start point has been specified during the
teaching-in movement. If no start point has
been specified here, the start points are auto-
matically specified.
Entry point x: XXm
9.
or
the last start point has been reached.
Manually specifying start points (01)
The first start point (01/X0) is pre-set and is 1 m
to right of the base station. Up to 3 other start
points (X1 to X3) can be programmed behind this
point. When specifying the start points, heed the
following:
■
Do not set start points too far from the base
station or too close to one another (02/f).
■
Only use as many start points as necessary.
* Entry Point
1.
or
* Point X1 at [020m]
2.
or
Select one digit in sequence with
and accept accordingly with
* Point X2 at [075m]
3.
or
Select one digit in sequence with
and respectively accept with
4. If necessary, specify further start points.
5. Return to the main menu with
7.4.3
Setting the mowing times
NOTE
There must be at least 30 min. between
programming the mowing times and the
mowing start. If not, the appliance only
starts at the next programmed mowing
time.
Settings
if no
if
or
.
or
.
.
Robolinho 700E/700I
Publicité
