Valor 563SCB Guide De L'installation Et Du Consommateur page 6

Installation
1. Fit the top baffl e under the top panel of the
appliance case. Secure with 2 thread forming
screws.
2. Fit the stand-off spacers. The stand-off spacers for
these installations are supplied fl at. These spacers
are left and right handed.
! Warning: Failure to install the stand-off spacers
may result in a fi re hazard.
a) Remove the 2 screws near each of the rear top
corners of the appliance and the 2 screws near
the rear top of each side.
b) Bend the spacers as shown.
c) Screw the spacers to the rear of the appliance
using the screws just removed.
d) Bend the side wings of the spacers to align the 2
holes in each spacer with those in the appliance
sides. Secure the spacers using the screws just
removed.
6
3. Mount the framing plate to the appliance.
Secure the
framing plate
and brackets to
the sides of the
appliance case
with 4 thread
cutting screws
supplied. Screw
from the outside
through the
access holes in
the framing plate.
Note: There are
alternate methods
of fi nishing around
the framing
plate—either
leaving it exposed
or recessing it and
covering it up with
the wall fi nish.
See page 4.
4. Install plinth and rear base support below fi rebox
(optional).
The purpose of the plinth is to allow the appliance
to be placed on a rough subfl oor, such as plywood,
without regard for the additional thickness of fl oor
fi nishes as the appliance bottom must otherwise be
placed at the fi nished hearth height or the front trims
will not fi t on the appliance properly.
a) Detach the burner module from the appliance by
removing its 11 screws.