Valor 563SCB Guide De L'installation Et Du Consommateur page 2

Kit Contents
Casting Tolerances
Due to the nature of cast iron, dimensional consistency
may vary from one unit to the next and some variation
in surface fi nish and fl atness is to be expected. We
have done our best to control and make allowance for
this; however some variation is inevitable.
Applications
The Valor model 530 heater with the 563SCB Senator
Front comes ready for installation as a zero clearance
unit into combustible type framing, without need for
a separate zero clearance kit. The 530 without the
standard zero clearance stand-off spacers may also
be installed into existing solid-fuel burning fi replaces
provided space and local codes permit.
Hearth Requirements
A 7/8" high plinth is supplied to raise the heater and
ensure a base at the proper height for the cast front to
sit on regardless of fl oor fi nish height. If not using the
plinth supplied, you MUST make allowance for fl oor
fi nish and raise (shim) the heater up so the bottom
of the heater sits at the fi nished fl oor/hearth height,
otherwise, the cast front will not sit at the proper height.
A non-combustible hearth is not required in front of this
appliance.
2
Insulation
pad
Rear Base
Support
Plinth
ZC Stand-offs
Barrier screen
Framing plate
Floor & Mantel Requirements
The 530 heater is approved for installation directly
on any combustible material other than soft fl ooring
material such as carpet or vinyl.
The 563SCB Senator Front may be installed with
combustible mantels provided clearances are
maintained as indicated in the Dimensions and
Clearances, and Framing diagrams below and on
the following page. Be aware that although safe,
some combustible materials and fi nishes at the
listed clearances may, over time, discolor, warp, or
show cracks. Care should be taken when choosing
materials—consult your fi replace dealer.
Top Baffl e
Mounting
Brackets
Cast front