Battery State Of Charge; Work Instructions - FUXTEC EA920 Mode D'emploi

Switching off
Release the On/Off switch.
◼

Battery state of charge

Press the button on the battery to check the state of charge at the state of charge indicator LEDs
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must be recharged. If none of the LEDs light up after the button is pressed,
the battery is faulty and must be replaced.
Cleaning the cutter bar (after each use)
Remove the battery.
◼
Clean the cutter bar after each use. Remove contamination, remains of blades etc.
◼
Spray the cutter bar with maintenance oil to ensure that the hedge trimmer has a long service life.
◼
Preferably use environmentally friendly lubricants, e.g. service sprays.
CAUTION!
Do not oil the hedge trimmer while it is running.

Work instructions

Check that all parts are firmly attached and obviously undamaged.
◼
Look over the working area and remove any obstructions.
◼
Remove all foreign objects from the hedge, such as wire or other parts, as these may block or
◼
damage the cutting mechanism.
Cut out thick branches beforehand using pruning shears.
◼
Pick up the power tool in both hands as specified.
◼
Original-Bedienungsanleitung FUXTEC_EA920_rev01
_______________________________________________
39