FUXTEC EA920 Mode D'emploi page 37

Adjust the shaft length
For high or low cutting the shaft lengt can be varied up to 34 cm.
Loosen the threaded sleeve on the shaft coupling (1.).
◼
Extend the lower shaft until the ideal handle length is reached (2.).
◼
Tighten the threaded sleeve (3.).
◼
Adjust the working angle
For high or low cutting the cutting head can be tilted.
Press up the locking button (1.).
◼
Set the required working angle (2.).
◼
Release the locking button until it clicks into place.
◼
Original-Bedienungsanleitung FUXTEC_EA920_rev01
_______________________________________________
37