Cutting Techniques - FUXTEC EA920 Mode D'emploi

Always cut at full engine speed.
◼
Start cutting only with the cutting mechanism running.
◼
Never touch wire fences or the ground with the running cutting mechanism.
◼
If cutting hedges over a prolonged period, interrupt your work more frequently and oil the cutter
◼
bar.
Switch the engine off and remove the battery:
◼
− to remove blockages (jammed clippings) from the cutting bar;
− if the unit behaviour changes or it vibrates unusually;
−
if you have come into contact with foreign objects or the ground;
− when taking breaks and leaving the unit unattended.
NOTE
If the power tool is damaged or vibrates unusually, it must be repaired by a service centre before it is used again.
After use, stop the motor and wait until all rotating parts have come to a standstill.
◼
Place the protection hood on the cutter bar.
◼

Cutting techniques

The hedge trimmer can be guided with its double-sided cutters forwards and back- wards or in an
◼
oscillating movement from one side to the other.
Cut the sides of the hedge first and then the top.
◼
Cut the hedge from bottom to top.
◼
Hold the hedge trimmer at an angle of 5–10° to the hedge to ensure a straight cut.
◼
Original-Bedienungsanleitung FUXTEC_EA920_rev01
_______________________________________________
40