Metrological Inspection; Explanation Of Symbols; Disposal - uebe visomat comfort form Mode D'emploi

E
• Cuff type US for an arm circumference of 17-25 cm
Part no. 2403005
PZN-00044960
• visomat mains adapter
®
Part no. 2400020
PZN-11870684
Subject to technical modifications.

5. Metrological inspection

Generally, it is recommended that a metrological inspection is
performed every two years. However, professional users in Ger-
many are obligated to do so in accordance with the "Medical
Products Operator Ordinance" (Medizinprodukte-Betreiberver-
ordnung).
This can be performed either by UEBE Medical GmbH, an author-
ity responsible for metrology or an authorised maintenance ser-
vice. Please refer to your national regulations.
Upon request, responsible authorities or authorised mainte-
nance services receive a „Test instruction for metrological inspec-
tion" from the manufacturer.
Please only submit the device for metrological inspection togeth-
er with the cuff and the instructions for use.
Important: No modifications, e.g. opening the device (except to
replace the batteries), may be made to this device without the
manufacturer's permission.
EN-62
Technical information Technical information

6. Explanation of symbols

This product complies with Council Directive 93/42/
EEC of 5 September 2007 concerning medical devices
and bears the mark CE 0123 (TÜV SÜD Product Service
0123
GmbH).
Degree of protection against electric shock TYPE BF
Consult the instructions for use
Keep dry
Device serial number
Reference number = item number
IP20
Protected against solid foreign bodies with a diameter
from 12.5 mm, no protection against water.
Manufacturer
Mains adapter information
When using the optionally available mains adapter:
Protection class II (double insulation)
For indoor use only
Direct current
Polarity inside plus

7. Disposal

Technical equipment and batteries do not belong in
household waste. They must be disposed of at appro-
priate collection and disposal points.
E
EN-63