Buccal Registration; Scanning The Quadrant And Jaw - Dentsply Sirona CEREC AF Notice D'utilisation

Dentsply Sirona
Operating Instructions (valid for Canada) CEREC AF, CEREC AF Connect
66 37 487 D3652
D3652.201.01.14.02 10.2017
7.4.5

Buccal registration

A buccal registration can be used to establish contact with the antagonist.
✔
The jaw with the preparation is scanned.
1. Scan the occlusal, buccal and lingual view of the antagonist (see the
section "Occlusal scan [ → 49]", "Buccal scan [ → 49]" and "Lingual
scan [ → 50]").
2. Perform a buccal scan of the bite block prior to completing the
registration. This buccal scan should be carried out close-up to the
preparation. To acquire sufficient geometry, capture the teeth of the
upper and lower jaw as well as 5 mm of the respective gingival areas.
7.4.6

Scanning the quadrant and jaw

The following scan regulation applies for the acquisition of a complete
quadrant or jaw arch.
The first (fourth) quadrant is scanned up to the opposite second front
tooth by moving the camera in parallel along the jaw arch.
Start the scanning process
➢ Position the camera occlusally above the last tooth on the right, to
start the scanning process.
7 Operation
51