Status Indicator - Dreame Bot Z10 Pro Mode D'emploi

Status Indicator

EN
The following table lists possible causes and solutions in terms of different light status. For more support,
please refer to the section "FAQ" in this manual.
Light Status Possible Cause
No power supply
Off
The robot in the DND period
The robot with full charge in sleep mode
White The robot not on the base
Breathing White The robot is charging
Blinking Orange Error
20
Solution
Check and ensure that the power supply for the base is normal.
/
/
/
Check whether a dust collection bag is installed. If not, install one.
Check whether the dust collection bag is installed in place.
Check whether the upper cover is closed. If not, close the upper cover tightly.
Check whether the bag is full. If so, replace it.
Remove debris around the dust intake of the robot and base.
Unplug the power cord of base, and check whether there are any foreign objects
that block the air duct cover. If any, clean them.
Check whether the dust bin of robot is installed.
For other errors, contact qualified technicians or after-sales service.
FAQ
Problem Type Solution
The battery level is low. Recharge the robot on the base, then try it again.
Robot does not turn on
The ambient temperature is too low (below 0° C) or too high (above 40° C). The operating temperature of the robot is
0° C to 40° C.
The base is not receiving power. Please confirm that both ends of the power cord are plugged in correctly.
Robot cannot recharge
Poor contact. Clean charging contacts of the base and robot.
There are too many obstructions around the base. Place the base in a more open area.
Please clean the signaling area of the base.
Robot cannot return to the base
Moving the robot may cause it to re-position itself or re-map its surroundings. If the robot is too far from the base, it
might not be able to automatically return on its own, in which case you need to manually place the robot onto the base.
Robot is malfunctioning Turn off the robot and then reactivate it.
A foreign object may be caught in the main brush, side brush, or one of the main wheels. Stop the robot and remove
Robot is making a strange noise
any debris.
The dust bin is full. Please clean the dust bin and dust intake.
Robot no longer cleans effi-
The filter is blocked. Please clean it.
ciently or leaves dust behind
A foreign object is caught in the main brush. Please clean it.
EN
21