How To Use; Battery Status Indicator - Dreame V10 Manuel D'utilisation

Installation
Installing the 2-in-1 Charging & Storage Mount
1. The 2-in-1 charging & storage mount is an optional accessory, you can install it based on your
requirements.
2. The mount should be installed in a cool, dry place near a power outlet, out of direct sunlight,
and away from moisture-prone areas, such as a kitchen.
3. Securely install the mount using mounting hardware suitable for the type of wall selected.
Make sure the installation area is clear of any pipes such as gas or water lines, and air ducts,
electric wires and cables, or drainage lines.
4. It is recommended to hire a professional to install the mount and to use protective clothing,
goggles, and other protective equipment where necessary.
5. Using an electric drill, mark and drill two 8 mm diameter holes into the wall where desired to
a depth of about 30 mm. Insert the wall plugs into the holes, position the mount, then fasten it
to the wall with the included screws.
7

How to Use

Note:
1. Fully charge the vacuum before using it for the first time. This will take about 4 hours.
2. Vacuum cannot be used while charging.
3. Vacuuming at turbo mode for a prolonged period will cause the battery to heat up, which
increases charging time. Allow the vacuum to cool down for 30 minutes before charging it.

Battery Status Indicator

106cm Off
Please read the Safety Instructions in this user manual before proceeding.
Blinking On
Low battery Fully charged
Half battery Fully charged
Nearly full Note: Once the vacuum is fully charged, the indicator will turn off after 5 minutes, and the
vacuum will enter the energy-saving mode.
8