Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE
INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PERSONAL
INJURY AND/OR PROPERTY DAMAGE.
•
1 – 789A-751A1 Hot Surface Ignitor
•
1 – Ignitor Mounting Bracket
Ignitor mounting bracket
The 789A-751KT1 is an aftermarket direct
replacement Hot Surface Ignitor Kit. This kit can be
utilized to replace a Silicon Carbide Ignitor (Carrier
model LH33ZS001 or valid cross reference) with
Rated Voltage:
120 volts + 10%, -15%, 50/60 Hz.
Cold Resistance:
20 to 100 ohms
Current:
0.4 to 1.2 amps at 120 ± 1.0 volts
Time to 1796 °F (980 °C): 8 seconds maximum at 102
± 1.0 volts
Ignitor Life:
100,000 cycles at 120 volts under typical
conditions
Agency:
CSA Certified
NOTE: Internal wires to ignitor connections to withstand
operational temperature of 482 °F (250 °C).
Ignitor Adapter Harness (use to connect
new nitride ignitor with old carbide
furnace connector)
emerson.com/white-rodgers
789A-751KT1
OEM Direct Replacement 120V
Hot Surface Ignitor
INSTALLATION INSTRUCTIONS
•
2 – ½" Sheet Metal Mounting Screws
•
1 – Ignitor Adapter Harness
•
1 – Installation Instructions
789A-751A1 Hot Surface Ignitor
Silicon Nitride on 33-1/3" Carrier/ICP Brand mid-
.
efficiency furnaces
PART NO. 37-7749001
1922
Publicité
Manuels Connexes pour Emerson White-Rodgers 789A-751KT1
Sommaire des Matières pour Emerson White-Rodgers 789A-751KT1
- Page 1 Time to 1796 °F (980 °C): 8 seconds maximum at 102 ± 1.0 volts Ignitor Life: 100,000 cycles at 120 volts under typical conditions Agency: CSA Certified NOTE: Internal wires to ignitor connections to withstand operational temperature of 482 °F (250 °C). PART NO. 37-7749001 emerson.com/white-rodgers 1922...
- Page 2 Fig. 5: Flame-side view of correct ignitor position Fig. 6: Gas-side view of correct ignitor position TECHNICAL SUPPORT: 1-888-725-9797 Emerson and White-Rodgers are trademarks of Emerson Electric Co. ©2019 Emerson Electric Co. emerson.com/white-rodgers All rights reserved.
- Page 3 (pulvérisation, écoulement ou pluie). • Une utilisation inappropriée et dangereuse peut être causée par des erreurs de REMARQUE : Les fils internes de connexion à branchement. l’allumeur peuvent supporter température opérationnelle de 250 °C (482 °F). DE PIÈCE 37-7749001 emerson.com/white-rodgers 1922...
- Page 4 Fig. 5 : Vue côté flamme de la position correcte de Fig. 6 : Vue côté gaz de la position correcte de l’allumeur l’allumeur SOUTIEN TECHNIQUE : 1-888-725-9797 Emerson et White-Rodgers sont des marques de commerce d’Emerson Electric Co. ©2019 Emerson emerson.com/white-rodgers Electric Co. Tous droits réservés.