R&G LP0284BK Instructions De Montage page 8

Page 8 of 21
I F O
F ITTING RIGINAL
 Remove the pair of tail bracket wiring cover bolts shown in picture 4 using a Phillips-head
screwdriver, followed by the pair shown in picture 5 using a 5mm Allen tool.
 Remove the wiring cover, then loosen the indicator securing bolts using an 8mm spanner, as shown
in picture 6.
 Slide the indicator clamping plate away as shown in picture 7, followed by the main body of the
indicator and wiring, as shown in picture 8.
 Remove the rubber indicator mounting blocks shown in picture 9, by sharply forcing the protruding
end down and pulling away from the tail bracket.
 Fit the mounting blocks to the R&G tail bracket (item 1) as shown in picture 10 and re-assemble
the indicator assemblies as original. Slide an indicator spacer (item 7) between the rubber block
and inner face of the tail bracket as shown in picture 10. You may need to snip an edge of the
spacers to be able to fit them around the blocks.
I F R&G M
F ITTING INI
 If fitting R&G mini indicators (R&G mini indicator product code RG371 for LED type, or
RG372 for Aero Style LED type), resistors to control the indicator flash rate may be
required (available separately, product code RGR0003).
 Place an indicator adaptor plate (item 5) either side of the mounting faces on the tail bracket, then
secure the indicator of choice to the plates using a 13mm spanner, as shown in picture 11.
 Slide a wiring cover (item 9) over each nut as shown in picture 12, then neatly wrap the wires
with the included heatshrink (item 8) and tidy the wiring with cable ties (item 11).
 Fit an indicator wiring connector (item 6) to the bullet connectors of each indicator (and resistors if
required), as shown in picture 13.
R&G T T A
AIL IDY SSEMBLY
 Secure the tail light (item 2) to the bracket using a 6mm spanner, then tidy with the rest of the
heatshrink and cable ties, as shown in picture 1. Finally, fit the remaining wiring connector to the
tail light bullet connectors.
 Offer the tail bracket assembly up to the original mountings as shown in picture 15, with the 4
bracket spacers sitting within the mounting bores, and all wiring fed through the cut-out.
 Secure the tail bracket to the bike with the 4x M6 bolts (item 3) and washers (item 4) using a
4mm Allen tool, as shown in picture 16.
 Correctly reconnect wiring to distribution box, then slide it back onto its holder. Refit passenger
seat.
 Test operation of all lights.
 Mount the licence plate (it may require drilling) to the bracket in a central position.
 Depending on local laws, attach enclosed reflector (item 11) in an appropriate location.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
H I :
ONDA NDICATORS
/A I
FTERMARKET NDICATORS
F :
ITMENT
R&G Racing
:
www.rg-racing.com Email:
LP0284BK
info@rg-racing.com