Bresser 4Cast MSB Mode D'emploi page 27

In the event the Meteotime icon changes to
ence on the unit. The sources of interference may come from electronic equipment such as TV-sets,
computers, household machines etc. It may also be due to lots of concrete, metal parts and electrical
equipment in the building. Your living area can also be the problem, if it is too far away from the radio-
controlled clock tower.
You are able to use the TEST-function to look for a better location.
• If you press the [TEST] button, the information window will display "SCAN".
• Pick up the unit and fi nd a better location.
• fl ashing: The test is running and the Meteotime signal reception is good. You can leave the
device at this location.
fl ashing: The test is running and the Meteotime signal reception is poor. You need to keep on
looking for a better location.
• The test lasts for around 1 minute. You can restart the test with the [TEST] button at any time, and
also discontinue the test by pressing the [TEST] button again.
• SCAN: The reception quality throughout the test will be indicated from 0 (very bad) to 9 (very good).
SWITCH CITY
• After inserting the batteries, the weather station searches for the radio-controlled time signal as well
as the Meteotime signal. After it has successfully received the Meteotime signal, the display shows
the default city "
• You are able to press the [SET] button to switch from the display of the city to weekday alarm,
single alarm or pre-alarm to time and date.
ALARM TIME & DATE
" in the information window.
, that means there are potential sources of interfer-
27
GB/IE