Stiebel Eltron DHE 18 SLi 25 A Instructions D'utilisation Et De Montage page 34

INSTALLATION
Installation
Mounting bracket for appliance replacement
Am existing Stiebel Eltron mounting bracket may be used when
replacing appliances (except instantaneous water heater DHF).
f Break through the back panel of the appliance for the thread- f
ed stud on the pre-installed mounting bracket.
DHF replacement
f Reposition the threaded stud on the mounting bracket (the f
stud has a self-tapping thread).
f Rotate the mounting bracket through 180° and mount it on f
the wall (the DHF logo is then turned towards the reader).
Installation with offset tiles
20
2
1
1 Minimum contact area of the appliance
2 Maximum tile offset
f Adjust the wall clearance and lock the back panel with the f
fixing toggle by turning it clockwise through 90°.
34 |DHE SLi
Turned appliance cover
The appliance cover can be turned for undersink installation.
electroni c comfort
f Remove the programming unit from the appliance cover by f
pressing the locking hooks and taking out the programming
unit.
f Turn the appliance cover (not the appliance) and refit the f
programming unit, ensuring that all locking hooks click into
place. When clicking the locking hooks into place, make sure
you press against the inner side of the appliance cover (shad-
ed area).
f Plug the set value transducer cable into the PCB (see chapter f
"Commissioning").
f Hook the appliance cover back in at the bottom and pivot it f
up onto the back panel.
f Ensure the all-round seal of the back panel sits tightly by f
pushing the cover gently forwards and back.
f Secure the appliance cover. f
Operation with preheated water
By installing a central thermostatic valve you will limit the max-
imum inlet temperature (see chapter "Appliance description /
Accessories").
electroni
c comfort
www.stiebel-eltron.com