R&G LP0221BK Mode D'emploi page 8

plate in position using two longer M6 bolts (Item 5), M6 washers (Item 2) and M6 nyloc
nut (Item 1) as shown in Picture 21.

Take the OEM sub-harness removed earlier and connect the bullet connectors to the OEM
Page | 8
indicators as original. If using R&G mini indicators, please connect them in this scheme:

Connect the licence plate illuminator Connector (Item 18) in this scheme:

Locate the wiring as original on the undertray and connect the connectors to the main
loom as original. Use cable ties (Item 15) provided to tidy up the wiring. Test all the
lights for correct operations.

Tighten the two longer M6 bolts just fitted earlier to secure the new licence plate bracket
to the bike.

Remove the M3 nuts and washers fitted earlier from the R&G licence plate illuminator.
From the kit, take cover plate (Item 11) and offer it in position so that all wires are tucked
in and all the mounting positions are aligned. Secure the back mountings with the M3
nuts and washers removed earlier. Secure the two front mountings using the remaining
two M6 bolts (Item 10), M6 washers (Item 2) and M6 nyloc nut (Item 1). Shown in
Picture 22.

Please ensure the assembly accuracy of the fitted components are the same as exploded
diagram shown in page 1.

Refit the rear panels as original.

Refit the centre side panels as original.

Refit the rider seat as original

Refit the pillion seat as original.

Check all the lights for correct operations.

Fit a licence plate to new licence plate bracket (it may require re-drilling).
IMPORTANT: THERE IS A SMALL CHANCE OF THE LICENCE PLATE
HITTING THE BACK WHEEL UNDER HEAVY LOAD AND OVER LARGE
BUMPS IN THE ROAD. IT IS YOUR RESPONSIBILITY TO CHECK FOR THIS
POSSIBILITY AND TAKE AVOIDING ACTION. FAILURE TO CHECK THIS
COULD RESULT IN SERIOUS INJURY.

Depending on local laws, attach enclosed red reflector (item 16) in an appropriate
location.

Please test the indicators, rear light and licence plate illuminator before riding.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
LHS INDICATOR:
Resistor YELLOW---------------- Sub-Harness ORANGE
Resistor BLACK ----------------- Sub-Harness GREEN
RHS INDICATOR:
Resistor YELLOW---------------- Sub-Harness LIGHT BLUE
Resistor BLACK ----------------- Sub-Harness GREEN
Please swap the connectors around if lights fail to illuminate.
Connector BROWN-------------- Illuminator RED
Connector GREEN -------------- Illuminator BLACK
Please swap the connectors around if lights fail to illuminate.
ISSUE 1 12/05/2017 (HH)
R&G Racing
www.rg-racing.com Email:
8
LP0221
info@rg-racing.com