R&G LP0221BK Mode D'emploi page 7


On the underside of the OEM licence plate bracket, remove three bolts A using 5mm
allen key and screw B using a phillips screwdriver (Shown in Picture 11).

Remove nut A in picture 12 using an 8mm socket and a wrench. Remove the OEM
Page | 7
reflector from the licence plate bracket.

Remove the two screws on the licence plate bracket arrowed in Picture 13 using a phillips
screwdriver.

Disconnect both indicator bullet connectors from the sub-harness. Please note the
orientation of the connectors during removal. Remove the sub-harness (as shown in
picture 14) from the licence plate bracket as it's to be reused at later stage.

On the upperside of the OEM licence plate bracket, remove two bolts A using 10mm
socket and a wrench, also remove bolt B using a 5mm Allen key as shown in picture 15.
Remove the metal bracket from the plastic.

On the OEM plastic licence plate bracket, remove either indicator by removing the bolt
arrowed in picture 16 using an 8mm spanner, remove the metal clamp plate and squeeze
the rubber grommet out from the plastic licence plate bracket. Repeat the procedure to the
other indicator.

From the kit, take the R&G licence plate bracket (Item 6), R&G licence plate illuminator
and the shroud (Item 8 & 9). Place the licence plate illuminator (Item 8) to the three-in-
line holes on the licence plate bracket (Item 6) as shown in picture 17. Secure with M3
nuts and washers provided. Apply a little amount of super glue around the top surface of
the license plate illuminator (Item 8) and place the licence plate illuminator shroud (item
9) over.

Feed the licence plate illuminator wires through one of the heat-shrink tube (item 14)
provided and using a suitable heat resource, shrink the tube to protect the wires.

If using OEM indicators, fit either indicator onto one of the indicator mount on the
licence plate bracket. Squeeze the indicator rubber grommet in and place the indicator
adaptor onto the indicator rubber grommet (Item 18) from the inside as shown in Picture
18. Secure using OEM indicator metal clamp plate and bolt removed earlier. Repeat the
procedure for the other indicator.

If using R&G mini indicators, take mini indicator adaptors (Item 7) from the kit. Place
two adaptors (item 7) on each side of the indicator mount on the licence plate bracket
(Item 6) so then the mount is sandwiched by the two adaptors. Place the mini indicator
through the adaptors and secure using the nut provided. Feed both indicator wires through
a tube of heat-shrink and shrink it using appropriate heat resource. Repeat the procedure
for the other indicator.

When using R&G mini indicators, RGR0001 is required to reduce the flash rate. Please
connect indicator and the RGR0001 wires in this scheme:

From the kit, take the bung (Item 13) and place it in the centre square hole on the
undertray as shown in Picture 19.

From the kit place the two shorter spacers (Item 4) on the two furthest front mounting
holes with the recess sitting against the licence plate bracket. Place the other two longer
spacers (Item 5) on the other two mounting holes on the licence plate bracket. As shown
in Picture 20.

Offer the whole tail tidy assembly towards the bike, align the four mounting holes and
feed all the wires through the rubber bung (Item 13) just fitted. Loosely fit the licence
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Indicator YELLOW------------ Resistor YELLOW
Indicator BLACK-------------- Resistor BLACK
R&G Racing
www.rg-racing.com
7
LP0221
Email: info@rg-racing.com