Publicité
checking correct operation (if illumination fails, swap the bullet connections around) (this connection
can also be soldered) as shown in picture 13.
Place one of the washers (item 3, labelled B in picture 14) onto one of the button head bolts (item 4,
labelled A in picture 14) and through one of the rearmost slots in the new licence plate bracket (item 1,
labelled C in picture 14) and then place one of the top hat shaped spacers (item 5, labelled D in picture
14) over the end of the bolt as shown in picture 14.
Page | 6
Offer the bracket into position as shown in picture below and engage the thread (do not tighten at this
stage).
Place the remaining washer (item 3, labelled B in picture 14) onto the remaining button head bolt (item
4, labelled A in picture 14) and through the remaining rearmost slot in the new licence plate bracket
(item 1, labelled C in picture 14) and then place the remaining top hat shaped spacer (item 5, labelled D
in picture 14) over the end of the bolt as shown in picture 14.
Engage the thread (do not tighten at this stage).
Place the two remaining plain spacers (item 2) over the front threaded extensions as arrowed in pictures
15 and 16 and use the original bolts to secure and tighten.
Tighten the remaining bolts.
Reconnect the wiring plug sockets as original (if the licence plate illuminator or indicators fail to work
swopping the bullet connectors should cure this).
Please check operation of all lights.
Use the cable ties (item 10) and cable clips (item 11) to tidy the wires, you may have to pull the wiring
loom through to the under-seat compartment to eliminate loose wires (please ensure to prevent the
wires from pulling back through).
Ensure the tail tidy is securely mounted and fully tightened.
Re-fit the seat.
Re-fit the licence plate (it may require drilling).
IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT FAR DOWN ON THE LICENCE
PLATE HANGER, THERE IS A SMALL CHANCE OF THE LICENCE PLATE HITTING THE BACK WHEEL
UNDER HEAVY LOAD AND OVER LARGE BUMPS IN THE ROAD. IT IS YOUR RESPONSIBILITY TO CHECK
FOR THIS POSSIBILITY AND TAKE AVOIDING ACTION. FAILURE TO CHECK THIS COULD RESULT IN
SERIOUS INJURY OR DAMAGE.
Depending on local laws, attach enclosed reflector (item 8) in an appropriate location.
Test the license plate illuminator and all lights before riding.
FITTING INSTRUCTIONS FOR MONSTER 1200 2014-
Please note on this model you will have to remove the original indicator brackets and the wiring will have a
slightly different routing.
Digital copies of these instructions are available to download from
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 18/11/2014 (NSY)
R&G Racing
Unit 1 Shelleys Lane, East Worldham, Alton, Hants GU34 3AQ
www.rg-racing.com
LP0166
www.rg-racing.com
Email:
info@rg-racing.com
Publicité
