Installation And Commissioning - Fronius PullMig AL216 Instructions De Service

Installation and commissioning

Mounting the
torch neck
Assemble wire
1
guidance insert
When cutting the inner liner to length, make sure that
-
-
-
* Contact tube with centering bore
** Contact tube without centering bore
Ø 4 mm (.16 in.): 40,0002,0014; 40,0002,0015
Ø 4,7 mm (.19 in.): 40,0002,0004; 40,0002,0017
1
2
4
3
1
no burr (sharp edges) protrudes into the inner liner at the cut location.
Hold the side-cutting pliers at a slight angle (the burr is then pulled towards
the outside).
Grind off the burr
IMPORTANT! Risk of coolant leakage
(on water-cooled welding torches) or
damage from overheating (on gas-coo-
led welding torches). When mounting
the torch neck, make sure that the swi-
vel nut is fixed firmly.
2
1
2
2
1
21