Hilti DX 76 Mode D'emploi page 10

▶ Do not leave unused or partly used cartridge strips lying around. Collect the used cartridge strips and
store the cartridge strips at a suitable, secured location.
▶ Follow all instructions relating to safety, handling and storage in the safety data sheet of the cartridges.
3 Description
3.1 Overview illustration, DX 76
3.2 Intended use
The product described is a fastening tool for driving nails, studs and fasteners into steel.
Use the product only in combination with the equipment designed for use with the fastening tool. Fastener
guides, piston and fasteners must be compatible with one another.
Use the product only with spare parts and accessories from Hilti and with cartridges and fasteners from
Hilti, or other suitable cartridges and fasteners.
3.3 Requirements to be met by cartridges
WARNING
Risk of injury by unexpected explosion!
requirements can lead to a build-up of unburned powder. A sudden explosion and severe injuries to the
operator and bystanders can result.
▶ Use only cartridges that meet the minimum safety requirements of your local statutory regulations!
▶ Adhere to the maintenance intervals as stated and have the fastening tool cleaned regularly by Hilti-
Service!
Use only the Hilti DX cartridges listed in this table, or other suitable cartridges that are compliant with the
minimum safety requirements:
• It is a requirement for EFTA countries that the cartridges must be CE-compliant and must bear the CE
mark of compliance.
• It is a requirement for the United Kingdom that the cartridges must be UKCA-compliant and must bear
the UKCA mark of compliance.
• It is a requirement for the USA that the cartridges must be compliant with the stipulations set out in
ANSI A10.3-2020.
• It is a requirement for the non-European member states of the C.I.P. that the cartridges must have C.I.P.
approval for the DX fastening tool used.
4 English
1
Fastener magazine MX 76
@
Contact pin
;
Mounting points for splinter guard
=
Cycling grip
%
Cartridge barrel (insertion)
&
Loading status control window
(
Adjusting knob for driving energy
)
Indicator for energy control
+
Padded end cap
§
Housing
/
Grip pad
:
Trigger
∙
Piston-guide locking lever
$
Piston guide
£
Splinter guard
|
Fastener stop piece
¡
Air vents
Q
Fastener guide X-76-F-15
W
Splinter guard for X-76-F-15
E
Piston
R
Piston stopper
T
Use of cartridges that do not meet the minimum safety
282472
*282472*