Black Diamond GUIDE BT Instructions page 20

4.9.6 Analog mode
The analog mode can be used for specific search strategies as well as for demo reasons (coupling positions).
Disabled by default, the feature can be enabled in the PIEPS APP device manager.
Press the button SCAN (1E) for 3 seconds while in
search mode. The analog mode starts with biggest
range.
Use SCAN to reduce range. Use MARK to increase
range.
Press SCAN for 3 seconds to exit the analog mode and
to return to regular search mode.
4.9.7 TX600 mode
The TX600 mode allows detecting the PIEPS TX600 – this is a mini transmitter for
dogs/equipment that works with 456 kHz.
Start TX600 mode: Press the buttons MARK (1D) and SCAN (1E) simultaneously for 3
seconds while in search mode. You see a "TX" indicated on the display (2M). Follow the
search phases as usual but use a reduced search strip width of 20 m. MARK can also be
used as usual, SCAN and analog mode is not available in TX mode.
Exit TX600 mode: Press MARK and SCAN simultaneously again for 3 seconds. Alternatively,
switch to send mode and then back to search mode. The "TX" indication disappears and
the GUIDE BT is receiving 457 kHz signals again.
NOTICE The recommended search strip width in TX600 mode is 20 m.
5. DEVICE MANAGEMENT WITH THE PIEPS APP
Bluetooth and the PIEPS APP allow a straightforward device management (e.g. software update) and additionally
provide a handy training mode.
Get the PIEPS APP (Android Play Store, iOS App Store), connect your BLACK DIAMOND GUIDE BT/RECON BT and
take advantage of all features!
To enable Bluetooth, press the button MARK (1D) while switching on the beacon.
Manual BLACK DIAMOND GUIDE BT/RECON BT | 04/2020 19 / 23