Black Diamond GUIDE BT Instructions page 17

Do an accurate direction adjustment before the
direction arrow disappears! You are then moving to
the transmitting beacon in best coupling position and
save time during the cross-like movements.
4.8.5 Pinpointing
Begin at the point of the lowest distance indicated.
Always probe perpendicular to the surface. Use your
lower hand as a "probe guide" to ensure the probe
follows a steady path. Follow a proven system until
you have a hit. Communicate a hit clearly to
companions. Leave the probe stuck for shoveling
guidance.
4.8.6 Multiple burials | MARK function
A multiple burial is indicated clearly on the display by the number of small human figures (2G, 2H).
Marking is possible from a distance reading of 5 m and is indicated by the MARK symbol (2E). Press the button
MARK (1D) briefly to "hide" the localized transmitter. A successful flagging is confirmed by a frame around the
human figure (2J). The display then indicates the direction/distance to the next strongest signal inside the
receiving range. If there are no further signals within the receiving range the display indicates "no signal".
Manual BLACK DIAMOND GUIDE BT/RECON BT | 04/2020
Move your beacon at a slow, steady speed of about 10
cm/s, keep it leveled close to the surface and do not
rotate your device. Search along the Y axis, determine
the lowest distance value, then follow along the X
axis. Always move past the point of the lowest
distance to verify the distance tendency. Mark the
point of the lowest distance reading and start
pinpointing.
prior to marking after marking
16 / 23