Black Diamond GUIDE BT Instructions page 19

4.9.4 Inclinometer
You can use the integrated three dimensional inclinometer to quickly check the gradient:
•
Put your ski pole in slope line at that point of the slope you want to measure.
•
Press the button SCAN (1E) for 3 seconds while in send mode.
•
Put your GUIDE BT next to the ski pole and read the indicated value. The display
switches back to send mode indication automatically after 20 seconds.
DANGER Risk of device loss during slope angle measurement
Although the GUIDE BT keeps transmitting while the inclinometer is active, the function
should only be used for training reasons. Never use the inclinometer function in avalanche
terrain!
4.9.5 SCAN & victim selection
Two SCAN modes are available:
The Regular SCAN provides a rough overview about the burial situation by indicating the number of victims within
certain distance ranges. This is the default setting. The Detailed SCAN shows direction and distance for each
victim and allows selecting a victim. The setting can be changed in the PIEPS APP device manager.
Regular SCAN
Press the button SCAN (1E) while in search mode.
The GUIDE BT scans the entire receiving range
and displays an overview. During the scan, don´t
move and hold the device steady.
reading 1: total number of victims within 5 m
reading 2: total number of victims within 20 m
reading 3: total number of victims within 60 m
The SCAN mode ends automatically but can also
be interrupted by another SCAN button press.
Detailed SCAN & victim selection
Press the button SCAN (1E) while in search mode.
The GUIDE BT scans the entire receiving range
and ends with indicating the direction and
distance to the first victim.
Use MARK (1D) to scroll through the closest 3
victims. The selected one is encircled (2J) – follow
the direction/distance reading to approach it. The
MARK function is not available in this mode.
Press SCAN to exit the Detailed SCAN mode and
to return to regular search mode.
Manual BLACK DIAMOND GUIDE BT/RECON BT | 04/2020 18 / 23