Black Diamond GUIDE BT Instructions page 18

Continuous wave indication | old-device-indication
Old analog transceivers are transmitting a continuous wave in addition to the pulse signal. To keep an impact at a
minimum, it is recommended to step a few meters away after marking such a transmitter.
Signal without continuous wave
The BLACK DIAMOND GUIDE BT/RECON BT identifies a continuous
wave and supports visually by flashing human figures.
4.9 GUIDE BT FEATURES
4.9.1 Vibra support
Send-Vibra: see chapter 4.3.
Vibra on initial signal detection: see chapter 4.8.2.
4.9.2 Extended group check & pro-mode
See chapter 4.4.
4.9.3 Mark range settings
In the PIEPS APP device manager the mark range can be changed from 5 m (default) to 20 m or to max. range.
Manual BLACK DIAMOND GUIDE BT/RECON BT | 04/2020
De-mark a single signal: press the button MARK
(1D) for 3 seconds.
De-mark all: switch to send mode and then back
to search mode. With the GUIDE BT you can also
use the SCAN function for a full reset.
Signal with continuous wave
17 / 23