ROBBE K-RAT II Manuel D'utilisation page 13

M o d e l l s p o r t
14
S E T U P / R U D D E R D E F L E C T I O N S
The following settings have proven themselves on countless test flights, but can be individually adju-
sted according to personal preferences.
Function Normal
Elevator + / -10 mm; 20% Expo
Rudder + / - 35 mm
Aileron +15 mm / -10 mm; 20% Expo
I N S T R U C T I O N S A N D U S E R M A N U A L
R E M O T E C O N T R O L I N S T A L L A T I O N , S E T U P
Finally, connect your receiver to the servos and
controller according to the connection diagram
of the transmitter manufacturer. The receiver can
be fixed at the rear end, underneath the canopy
frame, with e.g. Velcro tape.
Landing
3 mm (Low rudder)
/
30 mm upwards (max. possible travel)
15
16
S P A R E P A R T S
Spare parts
Fuselage without canopy or electric components
Wing (left and right), without electric components
Canopy
Horizontal stabilizer, elevator
Motor Ro-Power 3522-1000
Servos FS 155 BB MG
Spinner
Folding prop
Assemble the model complete with wings and tail
units. The aileron servos are connected to the
fuselage servo socket. The excess cable can easily
be stowed in the wing cavity.
With a slightly firmer pressure in the direction of the
fuselage, the „Clip Fixing" wing securing device
snaps into place immediately. This can be released
later with a wedge for disassembly or by applying
gentle pressure against the wing when holding the
fuselage in place.
Item number
26451
26454
26452
26453
20637
9106
20736
11x8"
13