Operation - Laserworld Proline Série Mode D'emploi

Manual: Laserworld Proline Series

8. Operation

1. Connect the power cable to the device and then to the mains
2. Insert key and turn it „on"
3. Press the „on/off" switch on. The „on/off" switch shines green now. Attention! The pro-
jector may emit laser beams immediately.
4. Mode selection:
Please use the push buttons below the LCD display to select the different modes
Auto mode:
Push the Menu button until MODE: AUTO is displayed. Press the ‚UP' and/or ‚DOWN'
buttons to browse the mode and press ‚ENTER' to select the desired program.
Music mode:
Push the Menu button until MODE: MUSIC is displayed. Press the ‚UP' and/or ‚DOWN'
buttons to browse the mode and press ‚ENTER' to select the desired program.
Control the sensitivity of the microphone by pushing the Menu button until MODE:
SETTING is displayed. Press the ‚UP' until MODE: SETTING - MUSIC is displayed
and the ‚UP' and/or ‚DOWN' buttons to set the sensitivity of the microphone. Press
‚ENTER' .
DMX mode:
Push the Menu button until MODE: DMX is displayed. Press the ‚UP' and/or ‚DOWN'
buttons to set the DMX address and press ‚ENTER' .
Connect a DMX controller to operate the laser.
The laser uses 16 DMX channels, so make sure that the next device uses an address that
doesn't overlap with this range.
page 8 / 42
Menu
Browse the Menu
LCD Display
Enter