OpeRATING The BLeNdeR
OpeRATING The BLeNdeR
1.
Ensure the Blender is correctly
assembled with the Safety Locking
Arm securely locked into the vertical
position.
NOTe
As a safety precaution, the Blender
will not operate if the Safety Locking
Arm is not securely locked into the
vertical position.
2.
Add food or liquid to the Blender Jug
ensuring not to exceed the 'MAX' line.
When filled at or near the 'MAX' line,
ensure to place one hand on the Lid to
avoid displacement during operation.
NOTe
If any liquid appears around the top
of the Motor Base, ensure the Blender
is turned off before removing the
Blender Jug from the Motor Base.
Immediately dry the Motor Base
with a soft cloth or paper towel to
absorb the liquid and check that
the Removable Silicon Gasket and
Removable Blade Assembly are
correctly assembled (see Assembling
the Blender, page 31 step 2).
34
3.
Place the Lid firmly into position on top
of the Blender Jug and insert the Inner
Lid by turning clockwise until securely
locked into position.
NOTe
The Lid features a patented ring-
pull removal. The ring-pull design
allows the Lid to be easily removed
with a simple leverage action, yet fit
tightly onto the Blender Jug to avoid
displacement during operation.
4.
Plug the power cord into a 110/120V
wall outlet. The START | OFF button
surround will illuminate..
NOTe
The button surround will illuminate
for 2 minutes before entering stand-
by mode. To re-activate the Blender
out of stand-by mode, press or turn
the START | OFF button.
5.
Rotate the START | OFF button to the
desired speed. For your convenience, a
blending speed guide is printed on the
stainless steel collar of the Blender Jug.