Technical Specifications; Disposal Of Old Electrical Appliances - cecotec CONGA 1790 TITANIUM Manuel D'instructions

ENGLISH
The robot does not charge
The robot does not return to the charging
base
The main brush does not rotate
The robot movements and routes are usual.

6. TECHNICAL SPECIFICATIONS

Product: Conga 1790 Titanium
Product reference: 05472
Output voltage: 19 V DC
Output current: 0.6 A
Power: 40 W
Battery: 14.4 V DC Li-Ion 2600 mAh
100-240 V AC ~, 50/60 Hz
Made in China | Designed in Spain

7. DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), specifies that old household electrical appliances
must not be disposed of with the normal unsorted municipal waste. Old
appliances must be collected separately, in order to optimize the recovery
and recycling of the materials they contain and reduce the impact on human
health and the environment.
42
Check if the indicator on the charging base
are lighted up. If not, contact the Technical
Support Service of Cecotec.
Clean the charging terminals with a dry cloth.
Check if the robot beeps when it gets to the
charging base. If not, contact the Technical
Support Service of Cecotec.
Remove objects within 3 ft/1 m to the left and
right side and within 6 ft/2 m of the front of
the charging base.
The robot will return quicker to the charging
base when it is close to it. If the robot is far
away from it, it will take longer to detect it.
Clean the charging terminals.
Clean the main brush.
Check if the main brush is properly installed.
Clean the sensors carefully with a dry cloth.
Restart the robot by turning the power switch
off and on.