cecotec CONGA 1790 TITANIUM Manuel D'instructions page 41

ENGLISH
in use.
If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place.
To replace the battery, follow the instructions below:
Unscrew the 2 screws on the battery compartment, remove the battery cover and the battery.
Fig. 38
Insert the new battery with the battery label facing up.
Fig. 39
Place the battery and the battery cover in its place and fix properly de screws back again.
5. TROUBLESHOOTING
Beeps while red light blinking:
01
02
03
02
Beeps while red light steady on:
01
40
Beeps
1
2
3
4
Beeps
1
Error
Gyroscope error
Bumper error
Free-fall sensor error
Low battery or
charging error
Error
Driving wheel error
Solution
Place the robot on a
stable surface and
restart it. Do not
move it.
Check the bumper
and remove any
object that could be
blocking it.
Check if the bumper
is dirty and clean the
sensor.
The robot has run out
of battery and must
be taken manually to
the charging base.
Solution
Check if the driving
wheel is blocked.