cecotec CONGA 1790 TITANIUM Manuel D'instructions page 42

02
03
02
Other possible situations
Problem
The robot cannot be activated
The robot stops operating suddenly
The schedule function does not work
Weak suction power
2
3
4
Side brushes error
Fan error
Main brush error
Solution
Make sure the main power switch is in the ON
position.
Make sure the battery is fully charged.
If the problem persists, turn the main power
switch off and restart it.
Check if robot is trapped or stuck on an
obstacle.
Check if the battery level is too low.
If the problem persists, turn the main power
switch off, wait for 2 seconds and restart it.
Make sure the main power switch on the
bottom of robot is turned on.
Make sure the time, time of day (AM/PM), and
the scheduled time have
been set correctly.
Check if robot's battery is too low to start
cleaning.
Check if any obstructions are blocking the
suction inlet.
Empty the dust tank.
Clean the filters with a vacuum cleaner or a
cleaning brush.
Check if the filters are wet.
Air-dry the filters completely before use.
ENGLISH
Check if the side
brush is blocked and
clean it.
Clean dust or other
objects in the air
ducts channel.
Check if the main
brush is entangled or
blocked and clean it.
41