Connecting Camera Power; Power Adaptor; Battery Compartment - weewell WMV850 Mode D'emploi

NOTE: The camera can also be placed on a flat surface, such as a Table or Shelf,
and no mounting hardware is required.
• Adjust the Viewing angle of the Camera
NOTE: You can install additional cameras (maximum of 4 cameras).When adding
cameras that were not included in the original box; you will need to pair up the
cameras with the receiver. Refer to the camera pairing section of this manual.

Connecting Camera Power

The Camera can be powered either by using the provided Power Adaptor, or
using Batteries (requires 4 x 'AA' type batteries, not included).
NOTE: Wireless cameras require a power source (either an electrical outlet or bat-
tery power) to operate. If you plan to permanently mount the camera in a loca-
tion, it is recommended to use the included Camera Power adaptor to prevent in-
terruptions in the image, as using battery power is intended as a temporary power
solution.

POWER ADAPTOR

Connect the Power Adaptor to the Camera.
Make sure the power adaptor is placed into
a grounded outlet or surge bar to protect the
camera from power fluctuations.

BATTERY COMPARTMENT

1. Remove the Battery Cover off the base of
the Camera.
2. Insert 4 x AA Batteries (not included) into
the Battery Compartment. Make sure to
correctly line up the Positive (+) and Nega-
tive (-) terminals of the batteries. Place the
Battery Compartment cover back on.
All manuals and user guides at all-guides.com
Make
WMV850 USER MANUAL
5V
I
9