Changing Baby Unit From Battery To Mains Power; Adjust Speaker Volume - weewell WMA440 Mode D'emploi

14
Switch on the Baby unit
1. To switch on, press .
that the unit is within range of the Parent unit.
Switching off both units
1. To switch Off, press
light goes off. Please note, if there is an alert displayed, you will
need to press the button twice.
Changing Baby unit from battery to mains
power
To conserve battery power on the Baby unit or when the batteries
are low or flat, plug the Baby unit into the mains. If currently
running on batteries and switched on, changing from battery to
mains power will be instant and not affect any of the settings.
You can use the Parent unit to monitor baby while it is charging.
Helpline
If you have any problems using your
WMA440 Baby Monitor
Please visit www.weewell.com
If you place the Parent and Baby units
too close together you will hear a high
pitched noise, this is normal. The units
are designed to be located at a distance
from one another, e.g. in separate rooms.

Adjust speaker volume

There are 5 volume levels (and off ) on the Parent unit.
The volume level is shown on the display bars, e.g. level 3 is
shown
1. Press or
Changing the volume setting on the Baby unit affects the volume
The Green Link light comes on to show
until the display goes blank and the link
Do not press the Talk button when the
Baby unit and Parent unit are positioned
in the same room. High - pitch noise will
be generated if the Talk button is pressed
when Baby unit and Parent unit are close
to each other or within 3 metres distance.
Put down mute the Parent unit before
you go into the nursery in order to prevent
any high-pitched whistle feedback.
. The volume level is displayed.