Spraying Technique - WAGNER ProSpray 3.39 Mode D'emploi

Starting operation
Security Code Screen
The Security Code screen allows the
user to set a four digit security code
to prevent unauthorized use of the sprayer. If a security code
has been set, the control system display will ask for the code at
startup. If the correct code is entered, the display will show the
Main Screen and the sprayer will operate. If the wrong code is
entered, the display will continue to ask for the correct code and
the sprayer will be disabled. To set or change the security code,
press the #2 key.
If the sprayer is new, no security code is set and
i
the Main Screen will appear at startup. When
setting a security code for the first time, the
"Enter Old Code Number" screen will appear, and
you will need to enter "1111".
Enter the old security code number to
access the screen that allows the code
change. If the wrong code is entered, the display will continue
to ask for the correct code and the security code cannot be
changed.
Enter the new security code. Once the
new code is entered, the display will
automatically ask that the new code be
re-entered for verification. If the same
new code is re-entered, the display will
confirm that the new code has been
accepted and return to the Main Screen.
If the new code is re-entered incorrectly, the display will return
to the "Enter New Code Number" screen and the process will
repeat.
If you forget or misplace your security code, you can contact
Wagner customer service for assistance.
To inactivate the security function, enter "1111" at
i
the "Enter New Code Number" screen (this is the
default code that leaves the sprayer unlocked).
As a result, the Main Screen will appear at sprayer
startup.
Prime Screen
The Prime screen appears when the
pressure control knob is set at the "MIN"
setting.
Rapid Clean Screen
The Rapid Clean screen appears when
the pressure control knob is set at the
RAPID CLEAN position and the PRIME/SPRAY valve is in the
PRIME position.
i If there is no action at any menu screen for 30
seconds, the display will go back to the Main
Screen.
GB
SECURITY CODE
MENU-1 CHANGE-2
ENTER OLD CODE
NUMBER
ENTER NEW CODE
NUMBER XXXX
RE-ENTER NEW
NUMBER XXXX
NEW CODE NUMBER
ACCEPTED
PRIME
RAPID CLEAN
32
5.

Spraying technique

Injection hazard. Do not spray without the tip
guard in place. NEVER trigger the gun unless
the tip is completely turned to either the spray
or the unclog position. ALWAYS engage the
gun trigger lock before removing, replacing or
cleaning tip.
The key to a good paint job is an even coating over the entire
surface. Keep your arm moving at a constant speed and keep
the spray gun at a constant distance from the surface. The best
spraying distance is 25 to 30 cm between the spray tip and the
surface.
Keep the spray gun at right angles to the surface. This means
moving your entire arm back and forth rather than just flexing
your wrist.
Keep the spray gun perpendicular to the surface, otherwise one
end of the pattern will be thicker than the other.
Trigger gun after starting the stroke. Release the trigger before
ending the stroke. The spray gun should be moving when the
trigger is pulled and released. Overlap each stroke by about
30%. This will ensure an even coating.
25 - 30 cm
i If very sharp edges result or if there are streaks
in the spray jet – increase the operating pressure
or dilute the coating material.
Spraying technique
25 - 30 cm
25 - 30 cm
ProSpray 3.39