Unpacking And Testing Appliance - Napoleon CLEARion Serie Manuel D'installation Et D'opération

All manuals and user guides at all-guides.com
general information
EN
1.5

unpacking and testing appliance

Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the appliance
operates properly by plugging the power supply cord into a conveniently located 120 volt, 15 amp grounded
outlet.
The appliance comes with medium density fiberboard (MDF board) installed on the sides. Remove fasteners on
each side (Fig. 1), and then discard both MDF boards.
Caution Label
W385-2236
Fig. 1
Use 4 new fasteners (supplied) on each side to cover MDF board fastener holes (Fig. 2).
#2 x 8
Fig. 2
7
W415-1767 / F / 07.20.18