Staufenbiel Epsilon XL V3 Instructions De Montage page 24

EN
13
14
15
16
24
Adjust the length of the pushrod if necessary and con-
nect the clevis to the elevator horn.
Slide the elevator halves to the carbon connectors.
Take care that they have a tight fit. If they are too
loose, apply a very small amount of CA to the car-
bon connector and let it dry completely. You can then
sand it until you reach the desired strength of the fit.
Connect the motor to the ESC and place the ESC un-
der the battery tray.
Place the battery on the tray and fix it with velcro like
shown in the picture.