Staufenbiel Epsilon XL V3 Instructions De Montage page 23

09
10
11
12
Slide the carbon elevator connectors into the desig-
nated holes in the tail.
Bring the elevator rocker arm lever to neutral position,
which is 0° angle. Create a linkage connection like
shown in the picture. Insert the pushrod into the fuse-
lage from the back. Bring the elevator exactly into
neutral position again.
Make a mark where the pushrod meets the servo
horn.
Use a Z-bend plier to bend the pushrod exactly at the
marked postion. Mount the pushrod to the servo horn
like shown in the picture.
EN
23