Door Reversibility - Zanussi ZRB24100WA Notice D'utilisation

Door reversibility

The side at which the door opens can be
changed from the left side (as supplied) to
the right side,if the installation site requires.
Before you start lay the refrigerator on its
back in order to gain access to the base, you
should rest it on soft foam or similar material
to avoid damaging the cooling pipes at the
rear of refrigerator.
1. Stand the refrigerator, use a flat bladed
screw driver to remove the 4 screw covers
on the refrigerator lid.
2. Unscrew and lift the lid from the rear and
remove it, them lift the upper door and
place it on a padded surface to prevent it
getting scratched.
3. Remove the upper hinge core, transfer it
to left side and tighten securely.
4. Remove the two flange screw, then re-
move the middle hinge that hold the lower
door in place. Lift the lower door and
place it on a padded surface to prevent
scratching it.
www.zanussi.com
ZANUSSI_ZRB24100WA-ZRB24100XA_CS-HU.indd 35
All manuals and user guides at all-guides.com
5. Remove the hinge hole cover from the
6. Remove both adjustable feet and remove
7. Unscrew and remove the bottom hinge
8. Make the middle hinge reverse its direc-
right holes as illustrated and transfer them
to the uncover hole at the left side.
the bottom hinge bracket by unscrewing
the bolts.
pin, turn the bracket over and replace it.
Refit the bracket fitting the bottom hinge
pin. Replace both adjustable feet. Transfer
the lower door to the opposite position.
Secure the door's level, put the bottom
hinge pin into the lower hole of the door,
then tighten the bolts.
tion 180°, then transfer it to the left posi-
tion. Put the middle hinge pin in the upper
hole of the lower door, then tighten the
bolts. Transfer the lower door to the oppo-
site position. Secure the door's level; put
the middle hinge pin into the lower hole of
the upper door
35
2016-02-16 11:00:40