Door Reversibility - Zanussi ZFU422W Notice D'utilisation

positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the appliance
should not be positioned below overhanging wall units.
Accurate levelling is ensured by one or more adjustable
feet at the base of the cabinet.
Warning! It must be possible to disconnect the
appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
A
Rear spacers
You can find the two spacers in the bag with documenta-
tion.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
B
4
Levelling
When placing the appli-
ance ensure that it stands
level. This can be achieved
by two adjustable feet at
the bottom in front.
Electrical connection
Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the do-
mestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.

Door reversibility

Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.
2
1
3
19