Changing / Adjusting The Spark Plug; Sharpening The Thread Cutter; Changing The Fuel Filter - FLORABEST BL FBS 25 A1 Traduction Des Instructions D'origine

G B I E N I
Replace the air filter (40) if it is worn,
damaged or heavily soiled (see
"Spare parts/Accessories").
Changing / Adjusting the
Spark Plug
Worn spark plugs or a spark gap
that is too great will result in a
power reduction of the engine.
1. Switch off the equipment.
2. Take the spark plug connector
(2) off of the spark plug (41).
3. Screw out the spark plug (41) an-
ticlockwise using the enclosed
maintenance key (see
4. Check the spark gap with the
aid of a feeler gauge (available
from specialist retailers).
The electrode gap must be
0.6 – 0.7 mm.
5. If necessary, adjust the gap by
carefully bending the spark plug
(41) earth electrode.
6. Clean the spark plug (41) with a
wire brush.
7. Reinsert the cleaned and ad-
justed spark plug (41) or replace
a damaged spark plug (41) with
a new spark plug (e.g. "TORCH
L8RTC" spark plug).
8. Reattach the spark plug connec-
tor (2).

Sharpening the Thread Cutter

Do not use the equipment
without a thread cutter or
with a defective thread cutter.
There is a risk of injury!
If the thread cutter blade is
damaged, contact our service
centre.
1 8
All manuals and user guides at all-guides.com
23).
Wear protective gloves to avoid
cutting injuries.
1. Switch off the equipment.
2. Unscrew the thread cutter (16)
from the protective cover (15).
3. Fix the thread cutter (16) in a
vice and sharpen the blade with
a flat file. File carefully and only
ever in one direction.
4. Screw the thread cutter (16) aga-
ing on the protective cover (15).
The spare parts which are to be
ordered can be found in the "Spare
parts/accessories" section

Changing the Fuel Filter

Never operate the equipment with-
out a fuel filter. Change the fuel
filter regularly.
1. Remove the filler cap (34).
2. Drain the fuel tank (7) into an
appropriate container.
3. Pull the fuel filter (42) out of the tank
with a hook and turn to pull it off.
4. Replace the fuel filter and place
the removed suction head back
in the tank.
5. Close the fuel tank (7) again
with the tank cap (34).
The spare parts which are to be
ordered can be found in the "Spare
parts/accessories" section
Winding up the spool
As an alternative to a new thread spool,
you can purchase a 2 mm or 1.8 mm-thick,
5 m-long nylon thread in specialist shops
and wind this yourself on the thread spool.